Skip to the record
Trusted by locals. Built for Noosa.

Original source · versioned page text

Attachment 2 - Sealed Final Judgment

Attached to the e-mail Pre-Request Response Application - MCU14/0008.03.

of 36

Page text shows just the words. Original shows the document exactly as it was published.

Page text read automatically using OCR, there may be inaccuracies

Very large file: it may take a few minutes

The original of this document is very large (19.6 MB). Opening the original or downloading it may take a few minutes. Please be patient and don't click again. The page text is quick to read. If you are on mobile data, it is best to wait until you are on Wi-Fi.

23. Unless otherwise stipulated by telecommunications legislation at the time of construction,
     the development must be provided with all necessary conduits, pits and pipes to
     accommodate the future connection of optic fibre technology telecommunications.
24. Certification must be submitted to Council from all relevant service providers which
     certifies that the development has met the requirements of this Decision Notice and all
     applicable legislation at the time of construction.
Earthworks and Retaining Walls
25. All fill and associated batters must be undertaken in accordance with an Operational
     Works approval, and contained entirely within the subject site unless written permission
     from the respective landowner(s) is provided to Council.
Damage to Services and Assets
26. Any damage caused to existing services and assets as a result of the development works
     must be repaired at no cost to the asset owner at the following times:
     (a) where the damage would cause a hazard to pedestrian or vehicle safety,
           immediately; or
     (b) where otherwise, upon completion of the works associated with the development.
     Any repair work which proposes to alter the alignment or level of existing services and
     assets must first be referred to the relevant service authority for approval.


ENVIRONMENT
Waste Storage
27. The developer must provide waste storage and disposal facilities in accordance with
     Planning Scheme Policy 9, Waste Management, including an external imperviously paved
     area correctly sized for all refuse and recycling containers and suitably screened from
     public places and neighboring properties.
28. A bin wash area is required with a cold-water tap, hose and drain outlet connected to
     sewer, via a bucket trap. The drain outlet must be designed to prevent storm water entry
     to the sewerage system which can be achieved by a bunded area, with a nib wall height of
     100mm maximum, enclosing a wash area of 700mm x 700mm minimum (max
     0.7m2). Alternatively the waste area can be roofed, or any other appropriate design
     approved by council that would prevent storm water entry to the sewer.
Noise
29. Written certification is required from a suitably qualified person confirming that sound
     pressure levels from all mechanical plant and equipment comply with the following :
     (a) Air-conditioning and Refrigeration
           • 7am to 10pm: Maximum level allowable = background + 5dB(A)
           • 10pm to 7am: Maximum level allowable = background + 3dB(A)
     (b) Pumps
           • 7am to 7pm: Maximum level allowable = background + 5dB(A)
           • 7pm to 10pm: Maximum level allowable = background + 3dB(A)




   Page 7 of 36
Log in to download the original file

Attachment 2 - Sealed Final Judgment.pdf · 19.6 MB (very large file)

Very large file: the download may take a few minutes. If you are on mobile data, it is best to wait until you are on Wi-Fi.

Searchable page text hides email addresses. Original files are unchanged and may show email addresses.

The supporting record

Open full page ↗

Source document

Analyse documents ↗Open full page ↗

My Comparisons

Choose two to four records of the same kind. Drag using a handle or use the “Compare” buttons.

Your selected records are saved in this browser for your account. Results use the filters on the page where you choose “Compare selected”.