Original source · versioned page text
MCU14/0056 Response to SARA - Consulting Report
The original of this document is very large (24.7 MB). Opening the original or downloading it may take a few minutes. Please be patient and don't click again. The page text is quick to read. If you are on mobile data, it is best to wait until you are on Wi-Fi.
Original PDF page 213, section 1. The text section number identifies this passage in the reader.
This document appears to be plans or drawings. Its page text below holds only the words printed on the drawings, without the drawings themselves, so it may be jumbled or hard to follow. To see the plans as drawn, choose Original above or download the file (both need you to log in).
Log in to see the plans as drawn 4. Cut the T sections to length, and pop rivet an L-bracket to one end of the T sections.
5. Insert the T section, with L-bracket under the lintel and secure L-bracket to the pit wall with an 8mm
Galvanised Dyna Bolt.
6. Secure second L-bracket to the opposite pit wall using a Dyna Bolt.
7. Pop rivet the free side of the T section to the second L-bracket.
8. Repeat the steps 5-7 for the second T section.
©2013 Stormwater360 | EnviroPod Installation Manual 5
See the original
The page text is free to read. Viewing or downloading an original file needs an account.
Log in to see the originalVery large file: the download may take a few minutes. If you are on mobile data, it is best to wait until you are on Wi-Fi.
Searchable page text hides email addresses. Original files are unchanged and may show email addresses.