Original source · versioned page text
MCU14/0056 Response to SARA - Consulting Report
The original of this document is very large (24.7 MB). Opening the original or downloading it may take a few minutes. Please be patient and don't click again. The page text is quick to read. If you are on mobile data, it is best to wait until you are on Wi-Fi.
Original PDF page 214, section 1. The text section number identifies this passage in the reader.
This document appears to be plans or drawings. Its page text below holds only the words printed on the drawings, without the drawings themselves, so it may be jumbled or hard to follow. To see the plans as drawn, choose Original above or download the file (both need you to log in).
Log in to see the plans as drawnTop Section Installation
1. Measure the internal dimensions of the pit at the height at which the plastic is to sit.
2. Trim the plastic to fit the internal pit dimensions, adding an extra 20mm to each side to ensure a tight
fit.
3. With the plastic bent slightly upwards, lower the Top Section into the pit, guiding the unit so that it
locates on the T Sections struts.
©2013 Stormwater360 | EnviroPod Installation Manual 6
See the original
The page text is free to read. Viewing or downloading an original file needs an account.
Log in to see the originalVery large file: the download may take a few minutes. If you are on mobile data, it is best to wait until you are on Wi-Fi.
Searchable page text hides email addresses. Original files are unchanged and may show email addresses.