Decision Notice MCU170510

25.   The following must be complied with during the construction of the required
      crossover/driveway:
      a.    The driveway surfacing must consist of either an approved hot mixed asphaltic
            concrete or patterned/plain concrete.
      b.    The driveway must be constructed so as not to concentrate stormwater runoff onto
            neighbouring properties
      c.    Where there is a pedestrian path, a matching crossfall must be provided for the
            driveway on the alignment of the path, for the full width of the path
      d.    The property access must be located a minimum of 1m clear of existing power poles,
            streetlights or other signage. The developer is responsible for any necessary relocation
            of existing services to provide this clearance and must contact the relevant service
            authorities and comply with their requirements in relation to these works.
      Earthworks and Retaining Walls
26.   All earthworks shall be undertaken in accordance with the provisions of AS 3798 Guidelines
      on Earthworks for Commercial and Residential Development, with geotechnical testing
      undertaken in accordance with Section 8 of the Standard, and to a minimum of ‘Level 1’ as
      defined in Appendix B. Test results as required by AS 3798, and a certificate of quality and
      uniformity of fill shall be provided by a RPEQ and submitted to Council prior to Council signing
      the Plan of Survey.
27.   Fall protection must be provided to retaining walls that are over 1m high
      Stormwater Drainage
28.   Appropriate scour protection must be provided at the outlet of all stormwater pipes including
      temporary outlets.
29.   Works associated with this permit must not adversely impact on the existing drainage
      conditions on other properties (eg by blocking or interfering with natural overland flows).
30.   Construction of all internal stormwater drainage works must comply with the relevant
      section/s of Australian Standard AS/NZS 3500.3.
      Environment
31.   Prescribed Water Contaminants (as defined in the Environmental Protection Act 1994) must
      not be released from the site or to waters within the site, or be likely to be released should
      rainfall occur, unless all reasonable and practicable measures are taken to prevent or
      minimise the release and concentration of contamination.
32.   Erosion and sediment control measures must be installed and maintained to minimise
      erosion on the site and to minimise the export of sediment and associated pollutants from
      the site. The erosion and sediment control measures must be designed, installed and
      maintained in accordance with current best practice standards (refer to advisory notes).
33.   Prior to the completion of the development, all site surfaces must be effectively stabilised
      using methods which have achieved effective short-term stabilisation and which will continue
      to achieve effective stabilisation in the medium to long-term (refer to advisory notes). For the
      purpose of this condition, an effectively stabilised surface is defined as one that does not, or
      is not likely to result in visible evidence of soil loss caused by sheet, rill or gully erosion or
      lead to sedimentation, or lead to water contamination.
      Damage to Services and Assets
34.   Any damage caused to existing services and assets as a result of the development works
      must be repaired at no cost to the asset owner at the following times:
      a.    where the damage would cause a hazard to pedestrian or vehicle safety, immediately;
            or
      b.    where otherwise, upon completion of the works associated with the development.



                                                                                         Page 8 of 13