Attachment 1 - Current Approval for MCU

                                                                                         132007.12.4

       All other clean stormwater, such as roof water, can be collected on site and discharged
       through a single underground drain line directly into the existing drainage system,
       bypassing the grease/oil arrestor and treatment system.
       A maintenance plan for the treatment devices shall be complied with for the duration of
       the approved uses.
       A Development Permit for Building Works shall not be granted until a Development
       Permit for Operational Works has been issued in regard to the drainage scheme.
47.    All site stormwater drainage shall be by means of a gravity system.
Sewer Mains
48.    All parts of the site shall be connected to Council’s existing sewerage reticulation
       systems and be constructed in accordance with Council’s standards and requirements at
       no cost to Council.
Town Water Supply
49.    All parts of the site shall be connected to Council’s existing town water supply and be
       constructed in accordance with Council’s standards and requirements at no cost to
       Council.
50.    For Multiple Uses (including Building Format Plans, Group Title Plans, etc) the
       development shall be served by:
       50.1. A single Body Corporate water meter to measure the total water consumption
             (including fire hose reels, but excluding fire hydrants and fire sprinkler systems),
             and
       50.2. Individual water meters to each tenement capable of being separately rated, and
       50.3. A fire service (fully testable single detector check with metered bypass), where
             applicable, for flows to fire hydrants and fire sprinkler systems (excluding fire hose
             reels).
Earthworks
51.    Filling works required on site shall be carried out in accordance with Section 3.8 of
       Council’s Engineering Design Standards Manual and so as not to cause the additional
       ponding of water on any adjoining lands or the blockage of, or interference with, any
       existing overland flowpaths. Detailed site surveys indicating natural surface levels and
       contours of the adjoining properties must be provided with the application for a
       Development Permit for Operational Works for Filling and Drainage.
       This may require the design and construction of drainage pipes and/or an overland flow-
       path within the development site that caters for drainage from the adjoining sites for a
       design storm with an Average Recurrence Interval of 1 in 100 years. A private easement
       for the Drainage of Water encompassing the drainage pipes or overland flow-path will
       also be required. In this regard a Development Permit for Operational Works shall be
       obtained.
       Should evidence be provided to Council indicating that no additional ponding of
       stormwater will occur on the adjoining properties the requirement for the drainage pipes,
       overland flow-path and easement shall not apply.
52.    Earthworks carried out on site shall not affect the structural integrity of any of the existing
       fences or structures that border the development site. Fences that are affected shall be
       replaced prior to the Building Certifier issuing the Certificate of Classification. In this
       regard any fences to be replaced shall be clearly shown on the plans submitted for
       Operational Works approval.




PD-DA-FM383/5-09/08/2010                                                            Page 7 of 16