Approved Plan - Landscape Specification prepared by URBIS - OPW24/0110

 Staking - Drive stakes into the ground, to approximately one third of their length, avoiding damage to roots.
 Install 3 times 50mm x 50mm x 2400mm stakes. Provide ties fixed securely to the stakes, one tie at half the
 height of the main stem. Others as necessary to stabilise the plant.
 Installation – Install as per manufacturers details. Re-tension after planting to provide a slightly loose fit,
 allowing for main trunk and canopy movement, which will provide wind support and promote root and stem
 growth.


 Plant Installation: 75L – On Grade

 Planting hole - Excavate a hole no deeper than the rootball. The hole is to be 4 times the diameter of the
 rootball. Rip the sides of the hole prior to planting.
 Watering dish - Form a 50mm high, 1000mm diameter mounded soil watering dish around the tree. Infill the
 watering dish with mulch. Fill the dish with water regularly during the initial plant establishment period.
 Staking - Drive stakes into the ground, to approximately one third of their length, avoiding damage to roots.
 Install 3 times 50mm x 50mm x 2400mm stakes. Provide ties fixed securely to the stakes, one tie at half the
 height of the main stem. Others as necessary to stabilise the plant.
 Installation – Install as per manufacturers details. Re-tension after planting to provide a slightly loose fit,
 allowing for main trunk and canopy movement, which will provide wind support and promote root and stem
 growth.


 Plant Installation: 45L – On Grade

 Planting Hole - Excavate a hole no deeper than the rootball. The hole is to be 5 times the diameter of the
 rootball. Rip the sides of the hole prior to planting.
 Watering Dish - Form a 50mm high, 600mm diameter mounded soil watering dish around the tree. Infill the
 water dish with mulch.
 Staking - Drive stakes into the ground, to approximately one third of their length, avoiding damage to roots.
 Install 3 times 50mm x 50mm x 2400mm stakes. Provide ties fixed securely to the stakes, one tie at half the
 height of the main stem. Others as necessary to stabilise the plant.
 Installation – Install as per manufacturers details. Re-tension after planting to provide a slightly loose fit,
 allowing for main trunk and canopy movement, which will provide wind support and promote root and stem
 growth.




 Tree and Palm Root Anchor & Foam Block: All Trees and Palms – On Structure
 Root Anchor product – Platipus tree anchoring systems – Specialist fixing system C/W Plati-Mat –
 RF2SPECIALP. Confirm right size for each rootball on site as per manufacturers documentation. Galvanised
 wire chokes, two-way ratchets tensioner with galvanises wire, 3x roper grips per leg, Plati-Mat rootball
 protection. Welded steel mesh (min 12mm 0.5” diameter) 100mm larger than the rootball to all sides.
 Installation – Place welded steel mesh on top of drainage cell over the geo fabric. Add rope grips. Add Sand
 filter layer. Fill soil as per manufacturers details. Re-tension after planting.

 Foam – Trees requiring to be elevated in order for the top of the root ball to sit flush with the surrounding
 finishes soil levels are to sit on foam block out. Trees are not to be elevated using soil or sand.




URBIS
URB-P0003847-000-SP.DOCX                                                                                     PAGE   45