Skip to the record
Trusted by locals. Built for Noosa.

Original source · versioned page text

Planning Application

Attached to the e-mail REC16/0007 Boundary Realignment Application - 183 Blanckensee Road, Black Mountain.

of 108

Page text shows just the words. Original shows the document exactly as it was published.

Page text read automatically using OCR, there may be inaccuracies

iii. adversely affecting the flow of water   to
in any overland flow path.                   accept any additional loading;
                                             AND
                                             S12.3 Car parking and maneuvering
                                             areas are constructed at a level that
                                             permits the parking area to drain from
                                             the site by gravity means, without the
                                             need for mechanical pumping; or
                                             S12.4 Basements for residential uses
                                             have flood immunity above the Q100
                                             where alternative means to mechanical
                                             pumping are used to achieve such
                                             immunity; or
                                             S12.5 Basements for non-residential
                                             uses have flood immunity above the
                                             Q100 that may be achieved by means
                                             of mechanical pumping where the
                                             mechanical feature is installed with
                                             adequate holding tanks and an
                                             alternative back up power source.
Sloping sites                                S13.1 Buildings are of split level        The proposal does not involve
O13 On sloping sites, buildings and          design that step down the slope or        the establishment of buildings or
structures are designed to maximise the      have a suspended floor construction;      structures.
use of natural slope and minimise the        (See Figure 8.1 below) AND
need for cut and fill.                       S13.2 Cut or fill is less than 2m in
                                             depth;
                                             AND S13.3 The distance between the
                                             ground and the lowest part of the floor
                                             of the building does not exceed 3m.

                                             Figure 8.1—Design for sloping sites
                                             (suspended floor)
Log in to download the original file

Planning Application.pdf · 3.1 MB (large file)

Large file: the download may take up to a minute.

Searchable page text hides email addresses. Original files are unchanged and may show email addresses.

The supporting record

Open full page ↗

Source document

Analyse documents ↗Open full page ↗

My Comparisons

Choose two to four records of the same kind. Drag using a handle or use the “Compare” buttons.

Your selected records are saved in this browser for your account. Results use the filters on the page where you choose “Compare selected”.