Council archive · source document
08/0746 - Op Works - Stormwater [As Published] · 142008.746
3 July 2003 -5- : 02682118(AD) Dense silty sand — indicated by dynamic cone probes DCP9, DCP3, DCP8, GDCP1 and GDCP5 at depths of 3.8 m, 5.1 m, 5.3 m, 3.6 m and 4.5 respectively. Dense sand was not encountered at any other locations within the depth of the dynamic cone test. (Dynamic cone testing continued to at least 5.0 m at all other locations, except location 1, which was tested to a depth of 8.2 m). Experience on other sites in the vicinity indicates that in general, the sand becomes dense at an average depth of 6 m to 7 m. Ground water was not encountered in any of the augered boreholes. 6.0 ENGINEERING COMMENT 6.1 Proposed development Architectural drawings prepared by Greg Gibbs Architects indicate that the development is to comprise a single storey level house of lightweight construction. Vertical loads that will be imposed on the foundation system from the house will be minimal. Additional vertical loads will be exerted on columns by proposed stormwater and sewage holding tanks. We are advised that access will be via a driveway from Allambi Rise. A landscape development plan prepared by Land Graphics (Ref. GG655, LAO2, Sheet 02, Issue A) indicates that planting is proposed on the slope undemeath the proposed house. The plants are to be maintained by a manually controlled spray irrigation system that produces a fine mist and is attached to the underside of the house. Land Graphics have indicated that the maximum irrigation rate that will be applied to maintain the proposed plant species would be in the order of 5 mm/hour. 6.2 Slope Stability Considerations As discussed previously, the majority of the site is presently maintained at an angle of 31 degrees to 37 degrees, and limited areas of the slope are as steep as 45 degrees. Some instability/erosion has occurred on the site. Under normal circumstances, loose dry sand would be stable in the Jong term at an angle considerably less than the angles presently maintained. The slope is maintained at unnaturally steep angles due to the reinforcing effect of the root systems of the vegetation on site. Hence, even partial removal of the vegetation will result in localised instability, with the near surface loose sands tending to form a slope angle approaching the natural angle of repose of loose sands (about.30 degrees). It is essential, therefore, that concerted efforts be made to ensure ‘that vegetation on site is not disturbed. The proposed landscaping beneath the house should act to minimise erosion of the near surface sands. However, we recommend the installation of a permanent surface crosion protection system in order to allow establishment of the proposed plants and to minimise surface erosion should the plants die. Golder Associates
See the original
The page text is free to read. Viewing or downloading an original file needs an account.
Log in to see the originalUsed in these records
08/0746 - Op Works - Stormwater [As Published]Related documentApplication case desk ↗
About this file
- File size
- 3.0 MB (large file)
- File type
No other editions are linked here.
Original file
Log in to download the original file
The download may take up to a minute.