2016-07-18 General Committee Meeting Notes

RECOMMENDATIONS ONLY – NOT THE FINAL DECISION OF COUNCIL
GENERAL COMMITTEE MEETING                                                            18 JULY 2016


        90.   As Constructed drawings and data shall be certified by a qualified experienced
              Civil Engineer for design intent, and a Licensed Surveyor shall certify the
              cadastre and the location, level and type of all services and structures. All of
              which shall be submitted to Council for checking and for Council’s records.
              The data must fully detail levels for all engineering works including but not
              limited to roadworks, pathway, sewer main, water supply main, finished ground
              levels and pavement surface levels and drainage structures that will become
              Council asset. The data shall be submitted in the Asset Design and As
              Constructed (ADAC) digital format. (Guidelines on the use of ADAC are
              available at www.adac.com.au).
              Approval of works shall not be granted until all As Constructed information has
              been supplied and accepted by Council.
        Waste Management
        91.   A Waste Management Plan (construction and demolition) shall be submitted
              prior to demolition, removal or relocation of any building other than a shed.
              Waste Management Plan (construction and demolition) is also required for
              construction of 15 or more dwelling units or for any business use of greater than
              500m².
              Waste Management Plans (construction and demolition) are required to be
              submitted in accordance with Planning Scheme Policy 11, Waste Management
              Plans see table below. Waste storage areas are to provide for adequate
              separation of all reusable, recyclable and waste materials. These shall be
              located so that they are convenient and safe to use. The Plan shall contain the
              following information:
              The site area for the storage and separation of waste is to be shown on the
              plan drawings accompanying the application.
              A waste management table as indicated below is to be completed showing how
              waste material is to be segregated - recycled – reused or disposed.
               MATERIALS ON-SITE                    DESTINATION
                                                    Re-use and Recycling                     Disposal
         Expected waste        Estimated     On-site            Off-site             *specify
         materials             volume        *specify proposed *specify              contractor and
                               (m³)          re-use or on-site  contractor and       landfill site or
                                             recycling methods recycling outlet      other disposal
                                                                                     site
         Excavation material
         Green waste
         Bricks
         Concrete
         Timber-please
         specify
         Plasterboard
         Metals - please
         specify
         Asbestos
         Other - please
         specify
        Note * If a demolition contractor is undertaking works, then the Waste Management table is to
        be completed by the demolition contractor.

                                                                                     Page 15 of 19