Appendix A - Decision Notice & Approved Plans · 132007.2446.05

      47.1.      Traffic control measures to ensure safety and traffic flow is maintained in Pacific
                 Avenue;
      47.2.      Limiting the routes for the heavy vehicles to the major road network and prohibit the
                 use of the local roads;
      47.3.      Maintaining pedestrian access and safety along the frontage of the site;
      47.4.      Indicate provision for on-site and off-site parking for the required workforce;
      47.5.      Indicate the location of loading and unloading areas,
      47.6.      Indicate the location of any “holding” areas for heavy vehicles;
      47.7.      Operating hours and
      47.8.      Strategy to protect Council’s existing infrastructures.
48.   Any damage caused to any public utility (eg pipelines, drainage pits, pathways, roads etc)
      during the course of construction shall be repaired to Council’s standards and at no cost to
      Council.
49.   Any alteration of any public utility or other facilities necessitated by the development of the
      land or associated construction works external to the site shall be at no cost to Council.
50.   The transportation of all materials to and from the site shall be undertaken in a manner such
      that no particle matter escapes onto a public road. All vehicles carrying materials either to
      or from the site shall be covered to prevent materials including dust being windblown from
      the vehicle.
      Refuse
51.   The developer must provide waste storage and disposal facilities in accordance with
      Planning Scheme Policy No. 9 “Waste Management Multi-Dwellings and Commercial and
      Industrial Premises”, including an external imperviously paved area correctly sized for all
      refuse and recycling containers and suitably screened from public places and neighbouring
      properties. A bin wash area is required with a cold-water tap, hose and drain outlet connected
      to sewer, via a bucket trap. The drain outlet is to be designed to prevent storm water entry
      to the sewerage system and this can be achieved with a nib wall 50mm high and up to 700mm
      x 700mm wide (max 0.5m²), or alternatively the waste area can be roofed, or any other design
      approved by Council.
52.   Refuse containers must be provided in accordance with the requirements of the
      Environmental Protection (Interim Waste) Regulation 1996 and (Waste Management)
      Regulation 2000, for the storage and collection of refuse.
53.   A Waste Management Plan (Operational) in accordance with Planning Scheme Policy No. 9
      “Waste Management Multi-Dwellings and Commercial and Industrial Premises”, must be
      submitted for the day-to-day operation of the development and approved by Council’s Health
      Section prior to issue of development permit for operational works.
      It is critical that waste areas are properly planned. A copy of Planning Scheme Policy No. 9
      explaining exactly how to predict waste quantities and design waste areas is available from
      Council and the web. The Plan shall include the following information: -
      •       The types of waste that will be generated from the activities approved within the
              development.
      •       Estimated volumes or tonnage of both recyclables and waste generated.
      •       Methods to be used for dealing with garden waste.
      •       Initiatives to minimize waste either by waste prevention, reduction, re-use or recycling.
      •       Description of procedures for getting all waste to the bins; the storage of bins and the
              collection of bins by the contractor.




                                                                                         Page 8 of 21