Whsmp · OPW16/0021

                                                                         SWMS:18 – A Pre Cast Panel Erection – N/A
Safe Work Methods
                                                                                                                                                       Responsible
                                                                               H                      Controls / Work Methods                                         Residual Risk
                                                                                                                                                       Person/s for
          Job Steps                   Potential Hazards         L    C    R    O              1. Eliminate 2. Substitute 3. Isolate 4. Engineer         Monitor &      L    C     R
                                                                               C                               5. Admin 6. PPE                            Review
                                                                C    3    H     5            The lifting force to overcome panel suction must        Hutchinson      D     3    M
Additional requirements for       Damaging the panels during
                                                                          13                  not be excessive. If the panel does not come free       Builders Site              9
lifting Tilt-up panels            lifting
                                                                                              when the crane indicator registers the combined         Foreman
                                                                                              weight of the panel, rigging and other suspended
                                                                                              dead load, lifting is to be stopped.                    Crane
                                                                                             Any wedging or jacking of the panel to assist release   Operator
                                                                                              is to be approved by the engineer.
                                                                                             Lifting clutches are to be fully engaged prior to
                                                                                              lifting occurring and must be compatible with the
                                                                                              Lift Inserts.
                                                                                             Lifting gear and sheaves are to be operable and in
                                                                                              good condition, and not to become tangled as the
                                                                                              crane hook is hoisted up.
                                                                                             A dogger to be in charge of slinging and
                                                                                              manoeuvring the panel into position
                                                                                             Assist crane crew
                                                                                             Panel crew members are not allowed to enter the
                                                                                              crash zone during panel placement.
                                                                                             STAND CLEAR until the panel is near final position,
                                                                                              and directed by rigger to assist
                                                                                             Daily Pre-starts to be undertaken prior to the lifts
                                                                                              between crane crew and panel crew to discuss safe
                                                                                              lifting controls
                                                                                             A minimum of a basic rigger to be in charge of the
                                                                                              connection of braces to the panel and final securing
                                                                                              to the deadman. Basic rigger will torque all anchor
                                                                                              bolts with calibrated rattle torque gun. Procedure
                                                                                              to be recorded and kept with the safety files.




584 Milton Road TOOWONG QLD 4066                          SWMS Developed by:   Jamie Gilbert                                                              VERSION 9 – September 2015
P: (07) 3335 5000 F: (07) 3335 5005                       Position:            National Health & Safety Co-ordinator                                                         Page 28
ABN: 52 009 778 330