Whsmp · OPW16/0021

                                                                                    Hutchinson Builders – ABN:52 009 778 330

                                      WHSMP:01 – Work Health & Safety Management Plan
                                                                                                                  Version: 9.2



                Aluminium ladders must never be used while undertaking electrical work.
                Any works to be performed from ladders must be done so from a platform ladder.
                Ladders in use on mobile scaffolds will be attached to the mobile scaffold, not in the
                 permanent structure.
                Is no longer than;
                   o 6 meters for a single ladder,
                   o Extension ladder for electrical work as defined in the Electrical Act 2002 – 9.2 meters or;
                An extension ladder 7.5 meters.

      15.4 Excavation & Penetrations
Excavations must be carried out in accordance with the SWMS to ensure a safe and efficient standard for
work is followed. Excavation includes, but is not limited to, breaking into:
                 Ground                                                Tunnelling
                 Trenching                                             Vertical Earth Cuts
                 Bulk earth excavation
Before any excavation work is carried out an Excavation Permit (HB-HSEQ-F-078) must be completed and
signed off by the person(s) requesting the permit, Site Manager/Foreman or person(s) in control of the
excavation.
                Any opening or excavation exposed in the ground, wall or structure that could cause an accident
                 by person(s)/equipment falling in/through should be roped off or barricaded as soon as
                 practicable. The barrier must be maintained until the opening/excavation is closed off or
                 backfilled.
                If the opening / excavation for ground excavations only have to be left open during the hours
                 of darkness the area should be clearly identified with the use of yellow flashing light.
                Any unusual or unexpected conditions, such as underground power lines, pipes or sewers must
                 be reported immediately.

      15.5 Coring / Drilling
Coring or drilling work must be carried out in accordance with the relevant SWMS and includes any coring /
cutting work where the worker will be breaking into:

                 Walls                                                 Ceilings
                 tilt – up panels                                      Ground
                 Soffit

Before any excavation work is carried out a Coring / Cutting Permit (HB-HSEQ-F-079) must be completed
and signed off by the person(s) requesting the permit, Site Manager/Foreman or person(s) in control of the
excavation.




                                                                                                                Page 45 of 58