Original source · versioned page text
2019-12-11 SM Agenda - Item 1 - Attachment 7 - Final New Noosa Plan - Part 8-10 Schedule Appendix - Clean version
The original of this document is very large (23.3 MB). Opening the original or downloading it may take a few minutes. Please be patient and don't click again. The page text is quick to read. If you are on mobile data, it is best to wait until you are on Wi-Fi.
This document appears to be plans or drawings. Its page text below holds only the words printed on the drawings, without the drawings themselves, so it may be jumbled or hard to follow. To see the plans as drawn, choose Original above or download the file (both need you to log in).
Log in to see the plans as drawnPerformance Outcomes Acceptable Outcomes
AO13.5
For “Y” and “T” shaped jetty heads—
(a) a maximum area 10.5m² excluding any walkway is
provided; and
(b) a walkway with a minimum length of 3 metres is provided
(Refer Figure 9.4.9.3D).
AO13.6
Gangways and walkways serving jetties and pontoons have at
least one rigid handrail fitted and meet the following—
(a) for dwelling houses – a minimum width of 750 millimetres
and a maximum width of 1.5 metres;
(b) for other residential uses –
(i) the gangway for a single berth pontoon has a
minimum width of 900 millimetres;
(ii) the gangway for a multiple berth pontoon has a
minimum width of 1.2 metres if fitted with one
handrail and 900 millimetres if fitted with a handrail
on each side;
(iii) the primary walkway to multiple berth pontoons has
a maximum width of 1.5 metres; and
(iv) the maximum width of a gangway is 1.5 metres.
AO13.7
In Noosa Sound, where quaylines are set, a jetty or pontoon does
not extend into the watercourse beyond the quayline;
OR
AO13.8
Where no quaylines are set, the maximum distance a jetty or
pontoon extends into the watercourse is 10m, unless it can be
demonstrated that a distance in excess of 10m is essential to
safely access a vessel from the jetty.
Editor’s Note— The quayline is measured from real property
boundary except where a relevant State Government Authority
permits the measurement from High Water Mean Springtide.
AO13.9
All attachments to jetties, including but not limited to boat lifts,
jetski cradles, floating berths and floating pontoons are located
within the quay line.
AO13.10
Pontoons are structurally capable of sitting on the sand bed.
Rollers and bracing should account for this situation.
AO13.11
Jetties and pontoons are free standing and do not rely on
connecting to any revetment wall or other structure.
Design, Construction and Safety Boat Ramps Table 9.4.9.3 Criteria for assessment (part)
**FINAL DRAFT Post Consultation 2019**
Page 4 of 16
See the original
The page text is free to read. Viewing or downloading an original file needs an account.
Log in to see the originalVery large file: the download may take a few minutes. If you are on mobile data, it is best to wait until you are on Wi-Fi.
Searchable page text hides email addresses. Original files are unchanged and may show email addresses.