DA20250050_DA Approval · 132010.574.01

                                                                                         2010/574




10.   The applicant is advised that burning off is an unacceptable method of disposal.
11.   Screening vegetation consisting of native, endemic species shall be planted to all setback
      areas and planted in accordance with Council’s Landscaping Plants and Guidelines PSP 3. In
      this regard the northern boundary setback area near the lower level bedroom 3 shall be
      planted at a higher density.
General – Planning Assessment
12.   The development shall be undertaken and operated in a manner that causes no detrimental
      effect upon the amenity of the neighbourhood due to the creation of excessive noise, lighting
      nuisance, or other emissions.
13.   Buildings and structures (including swimming pools, sheds, tennis courts, or outbuildings) shall
      not be constructed under overhead electricity transmission lines, or within any easements.
14.   All hot water systems installed shall be either solar; electric heat pump; or gas (LPG or
      natural).
Operational Works Assessment Branch
Earthworks
15.   Earthworks required on site shall be carried out in accordance with Council’s Planning
      Scheme Policy PSP5 – Engineering Design Standards, so as not to cause the additional
      ponding of water on any adjoining lands or the blockage of, or interference with, any natural
      watercourses.
16.   Earthworks carried out on site shall not affect the structural integrity of any of the existing
      fences or structures that border the development site. Fences that are affected shall be
      replaced prior to the Building Certifier issuing the Certificate of Classification.
Roof Water & Stormwater Drainage
17.   Roof runoff from any new dwelling shall be directed to a rainwater storage system or tank that
      is installed to ensure water from the rainwater storage system or tank is used for external uses
      (such as watering gardens, irrigation, ornamental ponds, water features, topping-up swimming
      pools, outdoor cleaning, etc) and for internal (ground floor) use in washing machine cold taps
      and toilet cisterns. All rainwater tanks are to be designed and installed in accordance with the
      Queensland Development Code (QDC) current at the time of building approval, and shall be
      part of the plumbing application for approval. The location and capacity of the tanks shall be
      clearly shown on the plans submitted for Building Works approval and any overflow shall be
      directed to the common property stormwater drainage system.
Geotechnical
18.   A geotechnical report, prepared by a registered professional engineer shall be obtained, and it
      should either:
      18.1. certify that the site is not at risk from landslide emanating from the site or from other
            land; or
      18.2. identify methods of stabilising all buildings, accessways and uses areas; and where the
            geotechnical report identifies methods of stabilising buildings, accessways and uses
            areas. The development shall implement those methods, which are recommended.
Sediment and Erosion Control
19.    Any person acting on this permit shall prevent erosion and sediment export from leaving the
       site. Site control measures such as silt fencing, controlled gravel access to the site and
       controlled disposal of waste, will be necessary.
       In this regard, a plan detailing the methods of controlling erosion and sediment in
       accordance with the Healthy Waterways document and fact sheet series titled “Controlling
       Stormwater Pollution on your Building Site dated 2006” are required to be submitted with the
       application for a Building Works Permit.
                                                                                     Page 3 of 8