B - Code Compliance

Waterways Works Code

PO14                                                  AO14.1                                                     AO14.1 to AO14.3 – Not Applicable
Boat ramps are designed and constructed to—           Where there is an existing revetment wall—                 The development does not include Prescribed Tidal
a) allow access by a wheeled boat trailer;            a) the level of a boat ramp surface at the revetment wall Works.
b) ensure that unacceptable risks to personal and         is no more than 150 millimetres above the top of the
   public safety are unlikely to be caused;               wall, not more than 500 millimetres below the top of
c) avoid cluttering of the waterways;                     the wall and not more than 200 millimetres above
d) avoid excessive traffic volumes within foreshore       the existing beach;
   areas and adjoining lands; and                     b) the ramp extends into the waterway no more than 9
e) ensure that visual amenity of the foreshore is         metres from a revetment wall;
   maintained.                                        c) the ramp is constructed at a uniform grade no steeper
                                                          than 20% (1 in 5); and
                                                      d) the outer end of the ramp is no more than 100
                                                          millimetres above the level of the beach (Refer Figure
                                                          9.4.9.3E).
                                                      AO14.2
                                                      No part of the ramp is to extend closer than 1 metre to
                                                      the prolongation of the boundaries.
                                                      AO14.3
                                                      The boat ramp surface profile is concave to allow
                                                      concentration of water to the centre of the ramp.

PO15                                                 AO15                                                        PO15 – Not Applicable
No new boat ramps are constructed within the No acceptable outcome provided.                                     The development does not include Prescribed Tidal
Noosa River system.                                                                                              Works.
Character and amenity - operational works within Noosa Waters Estate waterways
PO16                                                 AO16.1                                                      AO16.1 to AO16.3 – Not Applicable
Works are designed and sited to ensure—              For lots with watercourse frontage greater than 15 metres   The development does not include Operational
a) they are contained within the prolongation of in width, jetties are setback a minimum of 3 metres from        Works within Noosa Waters Estate waterways.
   boundaries of the lot;                            the prolongation of the boundaries (Refer Figure
b) that when a vessel is berthed it does not 9.4.9.3A).
   encroach over the prolongation of boundaries of AO16.2
   the lot;                                          For lots with watercourse frontage less than 15 metres in
c) a high level of visual amenity is maintained when width (including lots located in watercourse bends or at
   viewed from the watercourse and adjoining the head of the watercourse)—
   lands;                                            a) a joint application is made with the adjoining owner;
d) the works avoid conflicts with uses in the water,     or
   on the foreshore and adjoining lands;             b) where a joint application is not possible, jetties—