SUPERSEDED - Decision Notice MCU22/0082 OPW22/0134 [As Published]

               The property access must be located a minimum of 1m clear of existing power poles, streetlights
               or other signage. The developer is responsible for any necessary relocation of existing services to
               provide this clearance and must contact the relevant service authorities and comply with their
               requirements in relation to these works.
                      Earthworks and Retaining Walls
               53.    All earthworks shall be undertaken in accordance with the provisions of AS 3798 Guidelines
                      on Earthworks for Commercial and Residential Development and be generally in accordance
                      with BAX Engineering’s Earthworks Layout Plan (228-001-200 Revision C) dated 12 July
                      2022.
               54.    Fall protection must be provided to retaining walls that are over 1m high.
               55.    Slope and batters are a maximum grade of:
                      a.      1 in 6 where in proximity to waterbodies
               1 in 4 for grassed areas.
               1 in 3 for planted areas
               1 in 2 for combined structural engineering and planting solutions.
                      Stormwater Drainage
               56.    Appropriate scour protection must be provided at the outlet of all stormwater pipes including
                      temporary outlets.
               57.    Works associated with this permit must not adversely impact on the existing drainage
                      conditions on other properties (e.g. by blocking or interfering with natural overland flows).
               58.    Construction of all internal stormwater drainage works must comply with the relevant
                      section/s of Australian Standard AS/NZS 3500.3.
                      Erosion and Sediment Control
               59.    Prescribed Water Contaminants (as defined in Schedule 10 of Environmental Protection
                      Regulation 2019) must not be released from the site or to waters within the site, or be likely
                      to be released should rainfall occur, unless all reasonable and practicable measures are
                      taken to prevent or minimise the release and concentration of contamination.
               60.    Sediment and erosion control measures must be in place prior to works commencing. If such
                      measures are not in place or are not satisfactory, “on the spot” fines may be issued. Such
                      fines can be issued if sediments from the site are found to enter or have the potential to enter
                      Council’s stormwater system, natural waterways, any downstream stormwater filtration
                      system or adversely impacting on other properties. The sediment and erosion control design
                      and measures have NOT been approved, it is the site's Supervising Engineer who is
                      responsible for ensuring that the sediment and erosion control measures have:
                      a.      Been duly designed by an RPEQ or CPESC and constructed in accordance with "best
                              practise" methods,
               Been revised by an RPEQ or CPESC to address the issues raised by changes in the projected
               construction schedule and/or methods,
                      b.      Been revised to address predicted rainfall events, and
               Achieve the desired environmental outcomes.
                      Council may request further controls to be installed should the implemented measures be
                      found inefficient.
               61.    The erosion and sediment control measures must be designed, installed and maintained in
                      accordance with the supervising engineer instructions and the current best practice
                      standards * (Refer to Advisory Note).




                                                                                                       Page 8 of 14
Document Set ID: 22208842
Version: 4, Version Date: 14/12/2022